Has anyone here done the antenna mod referenced below on the AC2? I have about 400' to reach the tower node. Internal antennas will not cut it and the limited (and poor) reviews of the AC3 are not encouraging.
https://forum.mikrotik.com/viewtopic.php?t=153582
This appears to be the mating connector.
https://www.ebay.com/itm/143671356456?_skw=ms156+pigtail&itmmeta=01JHY2F...
TNX, Robert
https://forum.mikrotik.com/viewtopic.php?t=153582
This appears to be the mating connector.
https://www.ebay.com/itm/143671356456?_skw=ms156+pigtail&itmmeta=01JHY2F...
TNX, Robert
For expediency, lack of warranty issues and enough resources to have a good life (hopefully), I just bought an ac3. I found a different listing for the same item that had much more favorable reviews. After some more research and a recent presentation from Orv, the ac3 appears to be a good device for my application.
Robert
I am way too late to reply, but my choice for
'I have about 400' to reach the tower node.'
would have been an outdoor rated device
with a directional pattern such as a Mikrotik SXTqG.
73, Chuck
73, Robert
Hi, Robert:
A Mikrotik SXT is a 'wireless router combo with outdoor antenna' when installed outdoors.
AFAIK, commercial rated equipment is better RFI shielded (*) than residential grade Part 15 equipment.
(*) Better at keeping stray RF inside the device from getting out and better at keeping stray RF outside from getting in.
I hope this helps,
Chuck