You are here

Home » Forums » General discussion

Nanostation m2 firmware

3 posts / 0 new
Log in or register to post comments
Last post
Tue, 02/16/2016 - 18:06
#1
ki4vfp
Nanostation m2 firmware

 I have an older nanostation m2 that had been updated to ver. 5.6.2 XM firmware. I did the boot test and got BAD for version and GOOD for map.I suppose I need to install older firmware. What bin file do I need to use. I went to ubiquiti software site and I'm a little confused now. I don't want to brick it.First time on this forum.
Thanks   Bob

Top
Tue, 02/16/2016 - 21:48
AE6XE
AE6XE's picture
Find this specific firmware

Find this specific firmware image on the ubiquiti download site:  "XM.v5.5.11.28002.150723.1344.bin".   The release notes of this image support the NanoStation M2 and is the v5.5.x version that will roll back the uboot version to be compatible with AREDN.   Be sure to upload this from within the AirOS GUI, NOT the 'tftp' method.  Once this is done, run the boot test again to confirm "good/good".

AirOS V Firmware Revision History
====================================================================
Supported products

  * Bullet M2/M5/Titanium
  * Rocket M2/M2 Titanium/M3/M365/M900/M5/M5 GPS/M5 Titanium/M6
  * NanoStation M2/M3/M365/M5/M6
  * NanoStation Loco M2/M900/M5
  * NanoBridge M2/M3/M365/M900/M5
  * AirGrid M2/M5/HP/HP New
  * PowerBridge M3/M365/M5/M10
  * PicoStation M2
  * AirRouter/HP
  * PowerAP N
Top
Wed, 02/17/2016 - 18:33
(Reply to #2)
ki4vfp
Nanostation m2 Firmware

 AE6XE,
Thanks for the help.Everything worked fine. Installed older firmware on nanostation and airgrid m2.

Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer