Initial situation: Mikrotik hap ac lite and mikrotik sxtsq antenna bought new, flashed to 24.10, connected to port 5 of the HAP. Antenna not visible in dtd (not even after a long wait!) Same using an brandnew Ubiquity M5. same problem as with the Mikrotik SXTSQ. Not seen in dtd either. Workaraound: I flashed down both my new HAP ac Lite and the antenna back to 23.8. dtd is suddenly there! Everything seems OK. Then flashed again to 24.10, dtd stays and works. This means that there must be a bug in 24.10 (VLAN). But in migration takes the good config with it when migrating from the old version and thus circumvents the problem. Or to put it another way: don't initially flash new devices (antennas and also HAP ac lite) with 24.10 but instead take 23.8 and then upgrade. Hopefully this helps finding the bug!
You are here
Problems Antenna at Port5 of HAP AC lite is not seen (SXTSQ5 or Ubiquity M5)
Fri, 11/29/2024 - 11:19
#1
Problems Antenna at Port5 of HAP AC lite is not seen (SXTSQ5 or Ubiquity M5)
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer
Neither can I get any DTD when setting VLAN2 on port 4.
Any comments on this device? Would like some confirmation before reverting to 23.8. in case I wreck everything else again!
At the moment just sitting tight and hoping that the next FW will fix it...
https://www.arednmesh.org/content/dtd-walkthrough
https://www.arednmesh.org/content/unable-get-dtd-working-two-nodes-site
A solution seems to be loading a Nightly Build.
73, Chuck
I note your post to N7CPZ from 18 December - "evidence of a DtD bug in 3.24.10.0" - but am hesitant to use a Nightly on the node that I and others currently depend on, I may just wait for the next stable release. I will give a nightly a try on another node first, that doesn't provide tunnels to others.
However I am glad to hear that this is a known and addressable software issue and not something that I did to ruin my ac3.
Thanks for your reponse, 73 Robert