I configured the GS105E ver 2 as follows:I used the information provided under SOFTWARE down to NETGEAR SWITCHS number 10.
https://www.arednmesh.org/content/gs105e-1-lan-3-node-1-wan
I can't connect node A port 1 to the camera on LAN port 2 and I can not see node B on port 3 at all. Nothing is in port 4 node C or WAN on port 5 at this time.
Could someone check to see if this is the correct configuration please?
1 NODE A DtD
2 LAN Camera
3 NODE B DtD
4 NODE C DtD
5 WAN
Thank you,
Denis
You are here
GS105E Please Confirm
Fri, 03/13/2020 - 16:29
#1
KD1HA
GS105E Please Confirm
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer
Connect the camera to port 1, which will get its IP address from Node A on port 2.
Thank you Randy,
So don't plug Node A into Node A port, plug it into the LAN Port? I'm a bit confused so am I misunderstanding its use or is it labeled wrong? This is my 2ed use of a switch in the field and just trying to learn!
Denis
The legend at the bottom of the diagram you refeenced is incorrect. My mistake, sorry.
What currently reads as:
Port 2: LAN #1 on Node A
SHOULD read as: