Hello All,
This may be an unusual request but I would like to load a version of UBNT firmware on a node so I can use their spectrum analyzer for a site survey; and then put the AREDN firmware back on. I have 3.17.0 running on that node. When I did the upload (pre 5.6.2) on the node; it said it wasn't recognized or not valid or something like that (didn't save the screen shot).
Is the only way to do this is to TFTP down the image? I suppose I can save off the config and then load it again after doing the procedure.
Thanks In Advance,
John
AJ6BC
This may be an unusual request but I would like to load a version of UBNT firmware on a node so I can use their spectrum analyzer for a site survey; and then put the AREDN firmware back on. I have 3.17.0 running on that node. When I did the upload (pre 5.6.2) on the node; it said it wasn't recognized or not valid or something like that (didn't save the screen shot).
Is the only way to do this is to TFTP down the image? I suppose I can save off the config and then load it again after doing the procedure.
Thanks In Advance,
John
AJ6BC
Procedure is same as a TFTP install of AREDN.
73's,
John
AJ6BC