You are here

Home » Forums » Tunnels

Un-Installing Tunnel Server/Client Firmware

4 posts / 0 new
Log in or register to post comments
Last post
Mon, 05/07/2018 - 02:06
#1
WA8APB
WA8APB's picture
Un-Installing Tunnel Server/Client Firmware

What is the procedure to uninstall tunnel server/client functions from an AREDN node?

Related question:  Is it possible to operate multiple tunnel servers (hosted on different dtd nodes) using the same port forwarding pinhole (5525)?

Thanks

Bill Curtice  WA8APB

Top
Mon, 05/07/2018 - 02:48
KG6JEI
You can simply disable the
You can simply disable the tunnels serves/clients, this won’t remove the program from the backend but it will disable them.

If you want to completely remove them you can re-flash the node with the same version of the software which will leave you with a working node but without the tunnels.

it is not possible to use tunnel servers on multiple nodes using the same port forward, you can however have multiple nodes at the same site connecting as tunnel clients.

 
Top
Mon, 05/07/2018 - 08:27
k1ky
k1ky's picture
removal of Tunnel Module
You can also try removing the VTUN module under the Setup=>Administration=>Package Management=>Remove Package section:
 select Package vtun 3.0.3-2 (or whatever version vtun is listed)
 
Top
Mon, 05/07/2018 - 10:19
(Reply to #3)
K5DLQ
K5DLQ's picture
that does not remove
that does not remove everything.  the best way is to hold the reset for 15 secs (after the node if fully booted).   This will take you to the pre-config (firstboot) state.  (or, you can re-load the firmware as Conrad mentioned).  Both will have the same effect.
Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer