Hello UI users,
This is an FYI... My Ubiquiti LightBeam 5AC Gen2 arrived last week so yesterday (22-July-2024) was AREDN flash day.
My radio arrived with firmware V8.7.11 installed so an upgrade (or downgrade, in this case) was required. On loading 8.7.0, i did get the error message stating it wanted at least 8.7.4 and uploaded that one instead... PASS! The instructions flagged this so i was prepared.
Then, the default ‘scp…’ command threw up the “Unable to negotiate…” error, same for the 'ssh...' command. The instructions flagged this, had clear alternate command lines, and they worked... Nice! The hexdump command worked without issue, same for the chmod and the '/tmp/fwupdate.real...' command.
For the most part, the AREDNmesh.org installation instructions were relatively clear and it came up without any new problems. Given i did not want to brick the radio, i did have to 'read into' the instructions a bit and thankfully acted on the correct assumptions.
Next up, do a power load test to determine the actual Power level for this radio.
regards,
jim kn6pe
Cupertino, CA
This is an FYI... My Ubiquiti LightBeam 5AC Gen2 arrived last week so yesterday (22-July-2024) was AREDN flash day.
My radio arrived with firmware V8.7.11 installed so an upgrade (or downgrade, in this case) was required. On loading 8.7.0, i did get the error message stating it wanted at least 8.7.4 and uploaded that one instead... PASS! The instructions flagged this so i was prepared.
Then, the default ‘scp…’ command threw up the “Unable to negotiate…” error, same for the 'ssh...' command. The instructions flagged this, had clear alternate command lines, and they worked... Nice! The hexdump command worked without issue, same for the chmod and the '/tmp/fwupdate.real...' command.
For the most part, the AREDNmesh.org installation instructions were relatively clear and it came up without any new problems. Given i did not want to brick the radio, i did have to 'read into' the instructions a bit and thankfully acted on the correct assumptions.
Next up, do a power load test to determine the actual Power level for this radio.
regards,
jim kn6pe
Cupertino, CA
If you would, please share an example of AREDN install instructions that are more clear.
I know a guy that can edit and would love to improve the clarity of AREDN documentation.
73, Chuck
Eschew obfuscation, espouse elucidation.
Can you share with firmware you used.
I have tried with current stable and latest nightly build.
It flashes fine but the physical interface does not come up, i.e cannot ping 192.1681.1 or open the interface. I can log in with wifi MeshNode2G and set it up. and upon reboot connected to a setup HAP3 but it does not seem to get a IP.
Any help appreciated.
V