Tried two times to sysupgrade my Ubnt Powerbeam PBE-M5-400 using the following file.
aredn-2038-6fba065-ath79-ubnt_powerbeam-m5-xw-sysupgrade.bin
It went to the "Do not remove power during the update" page. Eventually, both times it reverted back to 3.22.12.0. No packages were installed and it was rebooted just prior to upgrading. Device was connected direct to my local computer thru a dumb switch.
I believe I'm using the correct file based on the notes. The 3.22.12.0 version did say it was using the ( ar71xx) rocket-m-XW hardware type. So based on the notes, I'm assuming the ath79 file referenced above will work?
Any suggestions or comments?
Regards
Bob
KE6GYD
aredn-2038-6fba065-ath79-ubnt_powerbeam-m5-xw-sysupgrade.bin
It went to the "Do not remove power during the update" page. Eventually, both times it reverted back to 3.22.12.0. No packages were installed and it was rebooted just prior to upgrading. Device was connected direct to my local computer thru a dumb switch.
I believe I'm using the correct file based on the notes. The 3.22.12.0 version did say it was using the ( ar71xx) rocket-m-XW hardware type. So based on the notes, I'm assuming the ath79 file referenced above will work?
Any suggestions or comments?
Regards
Bob
KE6GYD
Orv W6BI
Edited:
Bob: I had the same issue with NB 2038.
All: The PBE-M5-400 no longer uses a rocket image, it has it own image now.
73, Chuck
I actually read the notes for once and was aware of the separate image. Tried that as listed in my original comments, but no go. Orv has indicated that a fix on the latest nightly has been done, I'll give that a try in the next day or so.
Thanks
73
Bob
Thanks