You are here

Compatibility hardware CPE710 — TP-Link CPE710 - 5GHz AC 867Mbps, 23dBi, Outdoor CPE (CPE710)

7 posts / 0 new
Last post
VE3WZW
VE3WZW's picture
Compatibility hardware CPE710 — TP-Link CPE710 - 5GHz AC 867Mbps, 23dBi, Outdoor CPE (CPE710)


Compatibility hardware CPE710 — TP-Link CPE710
TP-Link Long-Range Outdoor Wireless Networking Solution - 5GHz AC 867Mbps, 23dBi, Outdoor CPE, Pharos Control (CPE710)

So i checked Compatibility hardware and could not find. I would love to order.   Any feedback?

Compatibility hardware CPE710 — TP-Link CPE710
 

Firmware downloads:     (created link)
 
Compatibility hardware:    (created link)
http://bit.ly/aredn

SHOULD I BUY ?  recommended backbone 100km range ? 

73,
mE 
www.ve3wzw.net 

ONTARIO Canada community and all Canada  (Forum subgroup)
Follow here ::  https://www.arednmesh.org/content/ontario-canada-community-and-all-canada

 
w6bi
w6bi's picture
CPE710
From what I hear, the CPE710 most likely won't be supported even in nightly builds until the fourth quarter at the soonest.

Orv W6BI
 
VE3WZW
VE3WZW's picture
Greetings and thanks for the

Greetings Orville impressive setup of towers and dishes/backbone, and thanks for the reply. I would have love to replace some older units with faster throughput.
What dish do you use or recommend?
recommended backbone 100km range

nc8q
nc8q's picture
TP-Link CPE710 - 5GHz AC 867Mbps

867Mbps, 23dBi, Outdoor CPE, Pharos Control (CPE710)

So i checked Compatibility hardware and could not find. I would live to order. Any feedback?

SHOULD I BUY ?

No, not yet.
Something better may become available before this device is supported.
Feedback:
About the 867 Mbps...
Not appropriate or feasible in typical AREDN usage.
Distance > 1 km
Bandwidth <= 20 MHz.

To get that rate requires Short Guard Interval and distance < 1 km and
160 MHz bandwidth in SISO or
80 MHz in 2-channel-MIMO.

With compatible devices, if you are not already getting 144.4 TxMbps now,
you will not get TxMbps 866.7 with these devices.

I hope this helps,
Chuck
 

VE3WZW
VE3WZW's picture
Greetings Chuck, wonderful
Greetings Chuck, wonderful feedback. what do you recommend as mentioned above.
nc8q
nc8q's picture
what do you recommend as mentioned above.

Hi, mE:

Microwave propagation depends largely on topology.
One needs to achieve 'near line of sight'.
You should study likely path links.
Especially, read
https://arednmesh.readthedocs.io/en/latest/arednNetworkDesign/networking_overview.html#
Without information on your local network plans, I have no clue where to begin.
73, Chuck

VE3WZW
VE3WZW's picture
It seems we may stick with

It seems we may stick with the Ubiquiti NanoBridge M5 wireless bridge - AREDN Mesh Network dishes used for many years.  (source ve3SP.com)



And follow the newer units that become available.
 

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer