Here's a few comments on the Meraki MR16:
- A couple of us have successfully flashed them with OpenWRT the with AREDN. Initially we tried Cucumber but had no success so went with the usual serial method. I've done two or three units but its been months since I've done so and my notes haven't been organized so it would take me a little time to figure it out again. :)
- Regarding the new FW release (3.22.1.0): At this moment the FW cannot be found on the 3.22.1.0 download page but does show up in this directory: http://downloads.arednmesh.org/firmware/
Look for: aredn-3.22.1.0-ar71xx-generic-mr16-squashfs-sysupgrade.bin
- I have found after running the Offline Map Submit Tool (OMS.exe) (https://www.arednmesh.org/content/aredn-offline-map-submit-tool-updated) that our Meraki's do not show up on the AREDN map. I don't know if there is an issue with the Meraki's (FW) or with the OMS tool.
Currently we have three of these on our network and really like them. The definitely were worth the $12 (each)!
73 - Mike
Meraki MR16's should now show on the AREDN map properly.
https://github.com/btvmeshnet/hardware/blob/master/platforms/Meraki/MR16... I loaded OpenWRT 19.07.5.
and then using OpenWRT web based GUI I used the "flash new firmware image" tool. loaded the "aredn-3.22.1.0-ar71xx-generic-mr16-squashfs-sysupgrade.bin".
Just remember to uncheck "keep settings". (if you send firmware and forget to uncheck keep settings your going to want to hold the reset button for 15 seconds)
I will keep testing but everything looks good as of yet.