I have a:
- bullet M2 XM
and
- bullet M2 XW
They are both running AREDN 3.20.3.1
The bullet M2 XM will go to a power level of 28 dB.
The bullet M2 XW will only fo to a power level of 25 dB.
Both devices have the red LED number 3 lit.
The bullet M2 XW has the LED number 6 lit.
The bullet M2 XM does not have LED 6 lit (it works during boot up but is not lit during operation)
They both seem to be running fine, but I am puzzled that they are different.
Thanks!
You are here
Puzzlement with an Ubiquiti Bullet M2 XM and Bullet M2 XW
Fri, 01/08/2021 - 17:48
#1
Puzzlement with an Ubiquiti Bullet M2 XM and Bullet M2 XW
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer
The red LED, LED 3, means OLSR is running. Until this is on there is no routing available.
Now to find out what the green LED 6 means!
Ok the Ubiquiti LEDS are described at:
- https://www.arednmesh.org/content/led-lights-31610
It would seem if there are only three LEDs for power output and one lan that the LEDS would be:
- LED 1 green: power
- LED 2 blinking green: lan active
- LED 3 red: OLSR on/mesh connected
- LED 4: off
- LED 5: off
- LED 6 high power
I am using the image:
- aredn-3.20.3.1-ath79-ubnt_bullet-m-factory.bin
when I use the image aredn-3.20.3.1-ath79-ubnt_bullet-m-xw-factory.bin on an XW device, the top gree LED lights.
When I use the HSMM 3.1 image on an XM device the top LED lights.
It looks like there is a bug in the aredn-3.20.3.1-ath79-ubnt_bullet-m-factory.bin which thinks there are four power LEDs and is trying to light a non-exiust LED.
My best guess so far.
How do I get assistance to debug this possible bug?
Thanks!