You are here

Home » Forums » Hardware » Nodes

need help setting up Basebox2 (RB912UAG2HPnD)

2 posts / 0 new
Log in or register to post comments
Last post
Sat, 12/28/2019 - 18:15
#1
KR6CV
need help setting up Basebox2 (RB912UAG2HPnD)

Hi,

I have been unable to connect to my new basebox via the browser interface (192.168.88.1).

I have turned off DHCP and assigned my computer 192.168.88.10 and still cannot connect via wifi

Winbox can connect with the node via ethernet but can I reset device settings through this program?

Trying to find out what firmware version I have to see if I can flash or "wait" for an update

Any advice would be welcome!

Stan KR6CV

Top
Sat, 12/28/2019 - 22:18
kc8ufv
kc8ufv's picture
Do you know which hardware
Do you know which hardware revision you have? There's a known issue with a new hardware revision....   https://www.arednmesh.org/content/heads-new-mikrotik-basebox-board-revision-breaks-arednopenwrt

Note that you wouldn't connect to a basebox AREDN node via wifi unless you set up an access point on the ethernet port, as the wifi radio would be used for connecting to other nodes. Also, when you load the AREDN firmware, by default, you need to turn on DHCP on your computer, and allow your computer to obtain an address. After that, try browsing to http://localnode.local.mesh
 
Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer