You are here

Home » Forums » Hardware » Network Switches

ProCurve 1700-24 switch

5 posts / 0 new
Log in or register to post comments
Last post
Sun, 07/07/2019 - 09:05
#1
LA9UI
ProCurve 1700-24 switch
I have tried to use a ProCurve 1700-24 switch with the setup from Understanding VLAN's by K5DLQ. I have 2 NanoStation loco M2 and 2 NanoBridge M5. It seems that I cannot control all the necessary parameters. I use 5 ports on the switch. DtD between a NanoBridge M5 and NanoStation loco M2 is working, but the RF connection between the two NanoBridge M5 is only intermittent.The RF connection between the NanoStations is solid. Can the ProCurve be used successfully with AREDN?

Hans-Petter  LA9UI
Top
Sun, 07/07/2019 - 09:46
K6CCC
K6CCC's picture
Please give us a little more
Please give us a little more detail about your issue.   The ProCurve should be just fine, but what does that have to do with a flaky RF link?
Top
Sun, 07/07/2019 - 13:29
(Reply to #2)
LA9UI
Seems that I need help
Seems that I need help configuring the ProCurve. I cannot find a place to tag or untag specific VLAN's on a port.
VLAN 2, tagged port 2 and 3.
VLAN 1 tagged port 2 and 3, untagged port 5.
VLAN 10 untagged port 1 and 2.

Hans-Petter  LA9UI
Top
Sun, 07/07/2019 - 16:37
K6CCC
K6CCC's picture
Are you using the GUI, the
Are you using the GUI, the menus, or command line to config the Procurve?  I have been configuring HP switches for a decade or so.  Should be able to help.
First of all, you need to enable VLANs.  If you don't enable VLANs, you can't configure them.
 
Top
Mon, 07/08/2019 - 05:09
(Reply to #4)
LA9UI
I use the web browser
I use the web browser interface in the switch. Firmware was VB.02.01, I just upgraded to VB.02.09
Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer