I scoured around a bit and couldn't find an answer, so I figured I'd post here and ask:
1) Is there any plan to change the NAT/Port Forwarding section of the MESH Setup page? It would be really helpful to be able to point a range of ports to a specific address (i.e.: if I wanted to point UDP/10000-10300 for VoIP, I'd rather not write 300 separate port forwards).
2) Failing that, is there any way to directly modify the iptables rules in a way that they won't get wiped out on a reboot?
Thanks es 73! VA3QR
1) Is there any plan to change the NAT/Port Forwarding section of the MESH Setup page? It would be really helpful to be able to point a range of ports to a specific address (i.e.: if I wanted to point UDP/10000-10300 for VoIP, I'd rather not write 300 separate port forwards).
2) Failing that, is there any way to directly modify the iptables rules in a way that they won't get wiped out on a reboot?
Thanks es 73! VA3QR
"
If you want to forward a range of ports, the Outside Port will accept a range in the form "2000-3000". Use a hyphen to separate the low and high values. When doing this, set the Inside Port to the low value of the port range. When forwarding a port range the outside and inside ports must be the same, moving them will not work."
Does that work?
VA3QR