I have two Ubiquiti NanoStation Loco M5 units.
Tried installing the first, seemed I bricked it.
Tried the second one and it went well, installed and tested, connected to the mesh.
Went back to the first one:
Put it in TFTP Server mode and PUT the Ubiquiti firmware on it and it works fine.
Put it in TFTP Server mode and PUT the AREDN firmware on it, It reboots and all, LEDs look like the functioning one but I cannot connect to it.
LEDs Power ON, LAN Blinking Next LED slow RED Blink, Last LED Green solid on.
Instructions say 192.168.1.1 connected to a computer interface set to DHCP.
I also tried the IP that I TFTP's to 192.168.1.20 and a few others, nothing.
I look at the laptop and it gets a gateway of 10.149.17.89 and an IP of 169.254.209.213, not good.
Windows Network Diagnostics states that the "Ethernet' doesn't have a valid IP configuration.
Any ideas?
Tried installing the first, seemed I bricked it.
Tried the second one and it went well, installed and tested, connected to the mesh.
Went back to the first one:
Put it in TFTP Server mode and PUT the Ubiquiti firmware on it and it works fine.
Put it in TFTP Server mode and PUT the AREDN firmware on it, It reboots and all, LEDs look like the functioning one but I cannot connect to it.
LEDs Power ON, LAN Blinking Next LED slow RED Blink, Last LED Green solid on.
Instructions say 192.168.1.1 connected to a computer interface set to DHCP.
I also tried the IP that I TFTP's to 192.168.1.20 and a few others, nothing.
I look at the laptop and it gets a gateway of 10.149.17.89 and an IP of 169.254.209.213, not good.
Windows Network Diagnostics states that the "Ethernet' doesn't have a valid IP configuration.
Any ideas?