Folks,
I purchased one of these devices to do some testing for a link to one of our hospitals.
I have been trying to load AREDN code into the device. I have gone at it from all directions.
So far no luck. I see the instructions that the device must be downgraded to Rev 6 code
appears specifically 6.45.7 or less. So I obtain the proper rev level and install upload it.
So far all is OK, but when I try to copy it over to the bootloader I get a message telling me
the code is too old to use newer one. So far I have not been able to find a way around
this to downgrade the bootloader then load in AREDN.
Has anyone been able to load AREDN into mANTBOX with serial number ending int
/r3 with the factory code level being greater than the one specified to upload AREDN?
You are here
mANTBOX 15s RB921GS-5HPacD-15S-US S# ending /r3
Tue, 06/06/2023 - 20:00
#1
mANTBOX 15s RB921GS-5HPacD-15S-US S# ending /r3
Tue, 06/06/2023 - 21:06
#2
I finally got the AREDN
I finally got the AREDN firmware to load. I remembered that I ended up having to load the RB firmware twice, the first load would reject the key, I poked at it until at some point I just re-sent the RB code again, and the board took it. So I went back and tried to load the .elf file again this time I again sent it a second time, waited then got the initial AREDN setup screen loaded the second file and now all is good. Not sure what was going on with having to double load the initial file but it worked.
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer