You are here

gl-inet300m16-ext flashing issue

4 posts / 0 new
Last post
k2exe
k2exe's picture
gl-inet300m16-ext flashing issue
Hey tried to flash a gl-inet300m10-ext which as I understood it was/is on the supported hardware list.  Got it flashed today and it seems that it claims its not supported?

flashed image: aredn-3.23.4.0-ath79-nand-glinet_gl-ar300m-nor-squashfs-sysupgrade.bin
md5: 2379bfac90e1346384fe54267e8bfedf
sha1: bf65563a0affa8e86f283cde17529d30dfbc527d

 

 node: 
model: GL.iNet GL-AR300M (NOR)

!!!! UNSUPPORTED DEVICE !!!!
boardid: GL.iNet GL-AR300M (NOR)
Device HAS BEEN TESTED AS UNSUPPORTED

br-lan 94:83:C4:26:FB:6C
eth0   94:83:C4:26:FB:6C
eth1   94:83:C4:26:FB:6B
tunl0  00-00-00-00-00-00-00-44-00-00-00-00-00-00-00-00
wlan0  94:83:C4:26:FB:6B

/proc/cpuinfo
system type		: Qualcomm Atheros QCA9533 ver 2 rev 0
machine			: GL.iNet GL-AR300M (NOR)
processor		: 0
cpu model		: MIPS 24Kc V7.4
BogoMIPS		: 432.53
wait instruction	: yes
microsecond timers	: yes
tlb_entries		: 16
extra interrupt vector	: yes
hardware watchpoint	: yes, count: 4, address/irw mask: [0x0ffc, 0x0ffc, 0x0ffb, 0x0ffb]
isa			: mips1 mips2 mips32r1 mips32r2
ASEs implemented	: mips16
Options implemented	: tlb 4kex 4k_cache prefetch mcheck ejtag llsc dc_aliases perf_cntr_intr_bit perf
shadow register sets	: 1
kscratch registers	: 0
package			: 0
core			: 0
VCED exceptions		: not available
VCEI exceptions		: not available


nvram
hsmmmesh.settings=settings

 

k2exe
k2exe's picture
Ahhhhh I see my mistake now I
Ahhhhh I see my mistake now I did not use the correct firmware.... hmmm any advice on how to get out of this pickle? as I don't see a way to re-flash?
 
nc8q
nc8q's picture
https://docs.gl-inet.com/en/2/troubleshooting/reset/
Note: If factory reset is not working.

You might need to follow the Uboot tutorial to debrick your router.
k2exe
k2exe's picture
Thank you the uboot trick did
Thank you the uboot trick did it for me.  If anyone finds this thread via search in the future the key was to hold down the reset button while powering it on wait for the red light to blink 5 times and then set a static ip directions said 192.168.1.2  which got me into the web portal at 192.168.1.1 where I was able to flash the correct version of the AREDN firmware to the device.  Thanks and 73 K2EXE Mark

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer