You are here

Background noise of MikroTik LDF 2

8 posts / 0 new
Last post
AC2OG
AC2OG's picture
Background noise of MikroTik LDF 2
Hello,
a recently flashed MikroTik LDF 2, mounted on a 35 cm offset dish, shows the following parameters:  Signal/Noise/Ratio
-80 / -88 / 8 dB 
 Why that bad background noise and how to improve it, if possible?
Thanks for any help
AE6XE
AE6XE's picture
 What does the snrlog history
 What does the snrlog history show with this neighbor -- to see over many hours?    These devices are unable to measure an absolute value.  What they do is measure the ambient noise and call that -95dBm.  Then, in an attempt to deal with other noise, it can raise the noise floor where the DSP attempts to decode the remaining signal.   
AC2OG
AC2OG's picture
LDF-2
Thanks, Joe for your comment,
The LDF-2 is linked on the -2 channel with an RB911G-2HPnD that is showing an ambient noise of -95dBm.
What kept my attention was the -88dBm on the LDF-2, that I have never seen before on a device.
Unfortunately, I don't know how and where to look for the snrlog you mention. 
AE6XE
AE6XE's picture
On the nodes' status page,
On the nodes' status page, click on "charts" button.  Then click on "archive" and select the neighbor in question.  What does the graph look like -- grab a screen shot?

Joe AE6XE
AC2OG
AC2OG's picture
LDF-2
here the archive
File Attachment: 
AC2OG
AC2OG's picture
LDF-2
hello Joe,
this is a new "snrlog" archive where you can see the noise before ( i.e. the one sent yesterday) and (today) after having changed the Azimut of the node toward the neighbor.  
File Attachment: 
AE6XE
AE6XE's picture
Best guess, changing the
Best guess, changing the direction of the antenna helped to not pickup whatever interference is at the site, if it holds over time.   
AC2OG
AC2OG's picture
LDF-2
Thanks, Joe for your advice.

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer