Joe AE6XE reports that the  Nightly Build available on Nov 28, 2018 will now include capability to use both wireless cards in the hAP ac lite device.  The 2GHz is the Mesh RF and now the 5GHz is a standard part 15 Access Point bridged with the LAN network.   This means that LAN mesh devices can be both on wifi and physically on the Ethernet port, both allocated the IP addresses assigned for the LAN network.   

For now, the 5GHz channels overlapping Doppler Radar are not selectable -- the "DFS" channels.   This will be an add on later to integrate in these channels. 

The code changes that make this possible, also make the following capability readily doable and are in the pipeline for the nightly build:

1) Activating the Nanostation XM devices' secondary Ethernet port to be standard AREDN functionality (and daisy chain devices with poe passthough).
2) Ability to enable/disable the following for single wireless card devices -- only one active on the wireless at a time or both disabled:
     a) mesh RF as we know today
     b) LAN Access Point for local wifi clients (with DtDLink routing to a dish on the roof and link to area mesh). 

Have fun!   Please post good/bad results as always.

The image belowis the Basic Setup page of the hAP ac lite with LAN Access Point settings.